Remote-access tunnels in Pulse
Remote-access tunnels and Run CLI for network devices are not available. This page says what you can use instead.
Remote-access tunnels to network devices are not available. You cannot open a tunnel to a switch, router, firewall or access point from The One Stack, and Run CLI on network devices is not available either.
What you will see#
- Tunnels and Run CLI are not listed in the Network section.
- If you open either page from a saved link, you are taken to the Network overview or shown a notice that remote access to network gear is not available. Nothing there opens a session.
- The Devices page has no Open tunnel or Run CLI action.
- Settings, then Network, does not show a Remote tunnels card while this is off. There is nothing there to save.
What you can use instead#
These run through your TOS agent today:
- Device discovery and adoption. See Pulse network monitoring and device discovery.
- SNMP monitoring of CPU readings and SNMP Walk. See Monitor network devices with SNMP.
To manage a device's own web page or command line, use your existing path to the device. Pulse does not provide one.
Related#
Was this article helpful?