Show technicians on the live map
Turn on the Map tab of Dispatch to see on-shift technicians who chose to share their location. Off by default.
Applies to Owner Admin Technician
The Map tab of the Dispatch board shows where technicians are right now. It is off by default, and it shows only people who chose to share.
Turn it on#
- Open PSA, then Settings, then Field Service.
- Open the Location tab.
- In Live map, turn on Show technicians' live location on the Dispatch map.
- Choose Save. You see Live location is on for the Dispatch map.
Turning it on shares nobody's location by itself. Each technician must still turn sharing on, and a technician is shown only while on shift. Technicians are told this.
Turn the switch off the same way. When it is off, the map stops showing technicians and any stored positions are dropped.
Read the map#
Open PSA, then Field Service, then Dispatch, then Map.
- The list on the right is On shift, with each person's status, how long ago they were last seen, and the job they are on.
- Select a person to find them on the map.
- The map updates about every 20 seconds.
- A position expires after a short time, so the map shows where people are now. It is not a trail of where they have been.
What you see when it is off#
The tab says Live location is off. An admin sees a link to Settings, then Field Service. Anyone else is told to ask an owner or admin.
Mobile location is a different setting#
Require location for field service staff on mobile is on the same Location tab. It is a separate setting. It pauses the mobile app for chosen people until location is on. It does not turn on the live map.
If it goes wrong#
- You do not see the Map tab. You do not have permission to view technician locations. Ask an admin.
- The map is empty. Nobody on shift has turned sharing on yet.
- The switch cannot be changed. Only an owner or an admin can. You see Only an owner or admin can change this.
What's next#
Was this article helpful?