Devices and assets 26 of 27

When a device will not check in

What to check when a computer stays missing or Offline after you install the agent.

Applies to Technician Admin

A computer is Online only after the agent checks in. Minting a token, or finishing the installer, is not that check-in.

Check it in order#

  1. Open All Devices and clear filters. A filtered list can hide the row. No devices match these filters means the filters are the problem. No managed devices yet means nothing has enrolled.
  2. Confirm the command you ran matches the operating system. Windows is an elevated PowerShell command. Mac and Linux need an administrator. See Install the endpoint agent.
  3. Confirm the token was for that customer, and that it is not Revoked or Expired under Active Tokens.
  4. Wait for a check-in, then refresh. No check-in yet on the dot means the enroll stamp is not Online.
  5. If the row exists and the dot is Offline, read Last Seen. no heartbeat in 15+ minutes is a stale check-in. The health badge is not measured while the device is offline.
  6. If the software should be gone, uninstall it on the computer. Deleting the row does not remove the agent. See Uninstall the agent.

If it goes wrong#

  • The token page said no installer is published. There is no file for that system yet. The token can still be valid later.
  • Failed to generate token. Please try again. Mint a new token. Do not reuse a command that failed the token check.
  • The row is in Deleted Devices. Choose Restore. See Delete a device and restore it.
  • You need a person on the machine and the row is online. Start Remote. See Connect to a device.